Disposal Work; Troubleshooting / Faq - Beko BEKOMAT 13 Original Installation And Operation Manual

Original installation and operation manual

14.2 Disposal work

At the end of its useful life, dispose of the product properly e.g. through a specialist company. Do not dispose of electrical
and electronic components via municipal waste disposal companies or household waste. Materials such as e.g. glass,
plastic are recyclable to a major extent and can be used again.
Fulfil the following prerequisites before disposal:
1. The BEKOMAT has been decommissioned and disassembled.
®
2. The BEKOMAT has been cleaned and freed of any condensate residue.
®
Operating material
Adsorption and filter materials, cleaning wipes and
protective clothing - soiled by oils or other hazardous
substances
Adsorption and filter materials, cleaning wipes and
protective clothing - with the exception of those classified
by 15 02 02
Packaging - paper and cardboard
Packaging - plastic material
Electric and electronic devices with the exception of those
covered by 20 01 21, 20 01 23 and 20 01 35

15. Troubleshooting / FAQ

Illustration
Prerequisites
Description / explanation
All LEDs off
TEST button has been
pressed but no condensate is
being drained
Condensate is only drained
when the TEST button is
pressed
Device constantly blows off
air
BEKOMAT 13, 13 CO, 13 CO PN25, 13 CO PN40
®
EU waste code
15 02 02
15 02 03
15 01 01
15 01 02
20 01 36
Troubleshooting
• Read the operating voltage off on the type plate
and check it
• Check whether voltage is applied to the terminals
of the power control board (PE, L, N)
• Check the plug-type connection of the connection
terminal on the control PCB
• Check feed and discharge lines
• Replace wear parts
• Check whether the valve clocking can be heard, to
do this press the TEST button several times
• Check the plug-type connection of the connection
terminal on the control PCB
• Install feed line at a gradient >3%
• Mount venting line
• Clean sensor tube
• Check whether the necessary minimum pressure
has been reached, if not:
0 install BEKOMAT
® vacuum discharge
• Clean entire valve unit
• Replace wear parts
• Clean sensor tube
55 | 64