Installation And Operating Conditions - Whirlpool ADN350S Instruction Manual/Product Information Sheet

If the appliance is unplugged (for cleaning, moving to another place, etc.), IT
–
MAY BE REPEATEDLY SWITCHED ON AFTER 15 MIN.
When performing activities, such as cleaning, maintenance or moving, the
–
appliance must be completely disconnected from power supply (by pulling the
plug out from the socket). Do not pull on the cord, but hold the body of the plug
instead.
Do not place any switched on electrical devices on top of the appliance because
–
this may cause ignition of plastic parts.
Do not place any dishes with liquids on top of the appliance and do not keep
flowers in vases or other liquid-filled vessels on the appliance.
Do not climb on or sit on the appliance, do not lean on or hang on the appliance
–
doors.
Do not use water spray and steam to clean the appliance.
–
Do not try repair the appliance on your own. If the appliance is out of order
and it is not possible to repair it by means of given recommendations, unplug
it, open the doors and call the service expert. Only a service representative
can remedy all technical or construction faults.
The appliance should be transported only in the vertical position.
The manufacturer will not be responsible for any damage of the appliance
that results from non-compliance with the instructions for transportation.

INSTALLATION AND OPERATING CONDITIONS

Positioning:
This appliance can be installed in a dry, well ventilated indoor where the ambient
•
temperature corresponds to the climate class indicated on the rating plate of the
appliance.
WARNING! The appliance should not be operated in an unheated room or
porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight.
The rear wall of the appliance, in particular, the condenser and other
elements of the cooling system must not contact other elements, which may
damage them, (e.g. central heating pipes and the water supply pipes).
Minimum distances from the heat sources:
- from the electric gas and other ovens - 30 mm,
- from oil or coal fired ovens - 300 mm,
- from built-in ovens - 50 mm
If there is no possibility of ensuring the above- mentioned distances, provide an appropriate
insulation board.
6