Description Of The Appliance, Basic Parts; Installation And Operating Conditions Of The Appliance - Whirlpool ADN140 Instruction Manual

Hide thumbs Also See for ADN140:
Table of Contents

Advertisement

Available languages

Available languages

DESCRIPTION OF THE APPLIANCE, BASIC PARTS

See fig. 1, page 1
1
Shelves
2
Condenser
INSTALLATION AND OPERATING CONDITIONS OF THE
Preparing the appliance for operation
It is recommended to prepare the appliance for operation with a helper.
Remove package. Lift the appliance away from foamed polystyrene base.
Therefore take out adhesive tapes from sides and simply lift the appliance up and
take out the board. Strip adhesive tapes off and open the door. Remove the spacer
above the door
If the appliance is brought in from the cold (temperature is not higher than +12
°C), you should wait for two hours before connecting it to the mains.
The appliance should not be connected to the mains until all packing and
transport materials aren't removed. Suitably dispose the packaging material.
Positioning
Place the appliance in a dry, well ventilated room.
WARNING! The appliance should not be operated in an unheated room or
porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight.
WARNING! The appliance must not touch any pipes for heating, gas or
water supply or any other electrical devices.
Do not cover the ventilation holes at the top of the appliances – it must be a good air
circulation around the appliance. There should be a gap of at least 10 cm between
the top of the appliance body and any furniture that may be above it. If this
requirement is not followed, the appliance consumes more electrical energy and its
compressor may overheat.
If the appliance is placed in a corner, a gap of at least 1 cm must be left between the
appliance body and the wall (see fig. 2, page 1).
The appliance must stand on a level surface and must not touch the wall.
necessary, regulate the height of the appliance by adjusting the levelling feet: by
turning them clockwise – the front of the appliance rises, by turning them counter
clockwise – it comes down. If the appliance is tilted slightly backward – the doors will
close by themselves.
3
4
5
APPLIANCE
5
Thaw water drip tray
Compressor
Cleaner
If

Advertisement

Table of Contents
loading

Table of Contents