Whirlpool ADN350S Instruction Manual/Product Information Sheet page 11

4. Unscrew the fixing screws 6 of the lower grid 5 and remove the grid by detaching hooks on
the bottom of the grid from the cabinet. The tongue of lock 7 must be in a horizontal
position. Move the cover 8 on the left side of the grid to the other side.
5. Unscrew four screws 10 securing the lower door hanger bracket 9 and two screws 10
securing the door support bracket 11. Remove the rackets along with screws and washers.
Screw the axle 12 of the lower door suspensions bracket into the next threaded hole,
symmetrical to the current position. Screw brackets 9 and 11 by swapping them;
6. Hang the door on the left side of the cabinet. Fasten the door on the upper left side with
bracket 1 with screws and washers, after turning the bracket 180
Attach the lower grid.
7. Unscrew the self - tapping screws 14 on the handle 13 and fasten the handle with the same
self - tapping screws on the side of the door. Plug up the remaining holes on the right side
with lids 15 in the sachet inside the refrigerator.
OPERATION PROBLEMS AND THEIR SOLUTIONS. What if ...
The appliance is plugged in to the mains but it does not work and the electricity
•
supply voltage indicator is not illuminated. Check that your house electricity supply
installations are in order. Check that the plug is correctly inserted into the electricity supply
socket.
The noise has become louder. Check that the appliance is standing stable, on a level
•
place. To make it level, regulate the front feet. Check if the appliance is not touching any
furniture, and that no part of the refrigeration system at the back part of the appliance body
is touching the wall. Pull the appliance away from any furniture or walls. Check that the
cause of increased noise isn't due to bottles, cans in the appliance that might be touching
each other.
Water has appeared at the bottom of the refrigerator compartment. Check whether
•
a thaw water channel space isn't blocked. Clean the thaw water channel space with a cleaner
intended for that purpose.
Water has appeared under the appliance. The thaw water collection tray has slipped off
•
the compressor. Place the tray on top of the compressor.
When the appliance door is opened, the rubber sealing gasket pulls out. The gasket
•
is smeared with sticky foodstuffs (fat, syrup). Clean the sealing gasket and the groove for it
with warm water containing soap or dishwashing detergent and wipe dry. Put the rubber
sealing gasket back into the place.
High temperature in appliance, the compressor operation pauses are short.
•
Ascertain whether the appliance door/doors are shutting tightly, whether the door wasn't kept
open longer than necessary when taking out or putting in foodstuffs or whether a large
amount of warm food was placed in the appliance.
The top of the appliance has condensation on it. The ambient relative air humidity is
•
above 65 %. Ventilate the room where the appliance stands and if possible remove the cause
of the humidity.
Remarks on the appliance operating noise. As the appliance operates and goes
through the freezing cycle, various noises will be emitted. This is normal and is not a
sign of any malfunction.
As the refrigerant circulates around the refrigeration system, it causes sounds like murmuring,
•
bubbling, or rustling. Louder sounds like popping or clicking may be heard for a short time as
the refrigerator compressor switches on.
10
o .