Table of Contents
Advertisement
② Make holes on the front panel
Make holes (x3) correctly at the following position. (2 screw holes, a wire hole)
Φ10mm
Hole for remote
control ler wiring
Hole for remote
control ler wiring
③ Remote controller installation
1. Push the driver into the groove of the lower body of the remote control, and then remove the
lower case.
2. Fixed the case of the remote control with screws onto the front panel.
3. Connect the remote control wiring to the main PCB of AHU kit.
4. Fit the body of the remote control to the lower case, and then install it.
Hole for remote
control ler wiring
Lower case of the
remote control ler
Screw(4x8)×2
(Supplied
Parts)
④ Attach the front panel
1. Replace front panel.
2. Fix the film to the front panel with the screw and washer.
3. Close the front panel.
4. Replace the two screws on the right side of the unit.
2×Φ3.1mm
Hole for screws of remote
control ler installation
Less than 180mm
Front view
Body of the
remote control ler
If the hole position is wrong or
different, the electrical
equipment parts in the box and
the wires may be damaged and
cause the trouble.
Φ10mm Hole
Hole for remote
controller installation
12
Caution
2×Φ3.1mm Hole
Top view
Caution
Use the two screws(4x8)
that come with this AHU
kit instead of the four
screws that come with the
remote controller.
Advertisement
Table of Contents
