Low Temperature; Filter Cleaning - Beko DS8440SXW User Manual

C
NOTE!
• You can select this function before the
program starts or after the program
starts.

Low temperature

You can activate this function only prior to start
of a program. You can activate this function
if you want to dry your laundry at a lower
temperature. The program duration will be
longer after it becomes activated.
End time
You can delay the end time of the program up
to 24 hours with end time function.
1.Open the loading door and place the laundry.
2.Select the drying program.
3.Press the End Time selection button and set
the delay time you wish. End Time LED turns
on. (When pressed and hold the button, End
Time proceeds non-stop).
4.Press the Start / Stand-by button. End Time
countdown begins. The ":" sign in the middle of
displayed delay time flashes.
C
NOTE!
• You can add or remove laundry within
end time. Displayed time is the sum
of normal drying time and end time.
End Time LED turns off at the end of
countdown, the drying starts and the
drying LED turns on.
Changing the end time
If you want to change the duration during the
countdown:
Pause the program and Turn the On/Off/
Program Selection button and cancel the
program. Select the desired program and
repeat the End Time selection.
Cancelling the end time function
If you want to cancel the end time countdown
and start the program immediately:
Pause the program and Turn the On/Off/
Program Selection button and cancel the
program. Select the desired program and press
the "Start/Pause" button.
Drum Light
You can turn on and off the drum light by
pressing this button. The light turns on when
the button is pressed and turns off after certain
time.
Dryer / User Manual
5.6 Warning indicators
C
NOTE!
• Warning indicators may vary depending
on the model of your drying machine.

Filter cleaning

When the program is completed, the warning
indicator for filter cleaning turns on.
Water tank
If the water tank fills up while the program
continues, the warning indicator starts flashing
and the machine goes into stand-by. In this
case, empty the water tank and start the
program by pressing the Start / Stand-by
button. Warning indicator turns off and program
resumes.
Cleaning of filter drawer/
heat exchanger
Warning symbol flashes periodically to remind
that filter drawer must be cleaned.
5.7 Starting the program
Press the Start/Stand-by button to start the
program.
Start/Stand-by and Drying indicators turn on to
show that program started.
5.8 Child Lock
The drying machine has a child lock which
prevents the program flow from being
interrupted when the buttons are pressed
during a program. When the Child Lock is
activated, all buttons on the panel except
the On/Off/Program Selection button are
deactivated.
Press the Audible Warning button for 3
seconds in order to activate the child lock.
The child lock has to be deactivated to be
able to start a new program after the current
program is finished or to be able to interfere
with the program. To deactivate the child lock,
keep the same buttons pressed for 3 seconds.
C
NOTE!
• When the child lock is activated, the child
lock warning indicator on the screen
turns on.
When the child lock is active:
The drying machine runs, or in stand-by state
the indicator symbols will not change upon
changing the position of the program selection
button.
15