Pre-Wall Installation Of The Conduit Box; Installing The Nxd Panel Within A Conduit Box - AMX Modero NXD-700Vi Operation/Reference Manual

3. Remove the wiring knockouts from the left side of the conduit box (CB-TP7) (FIG. 11) to
accommodate the cables being threaded through to the NXD touch panel.
Remember that when mounting this conduit box, the NXD mounting tabs must lie
flush against the outside of the sheetrock.
4. Thread the incoming power, RJ-45 audio/video, Ethernet, and USB wiring through the knockouts
(use of the left wiring knockouts are recommended with this installation).
Leave enough slack in the wiring to accommodate any re-positioning of the panel.
5. Install the drywall/sheetrock before inserting the main NXD unit into the CB-TP7.
The NXD-700Vi can be installed either directly into the (optional) CB-TP7 or other solid surface
environment using the two different mounting options: drywall clips or solid surface screws. The
following sections describe mounting the touch panel directly into a pre-wall conduit box, a solid surface
or drywall, and optional NXA-RK7 Rack Mount Kit.

Installing the NXD panel within a Conduit Box

The conduit box must be mounted prior to continuing this section. Refer to the procedures in the
Pre-Wall Installation of the Conduit Box section on page 16 for detailed pre-wall installation
instructions. Verify that all necessary cables have been threaded through the knockouts on the left of the
conduit box and the connections have been tested prior to installation of the NXD-700Vi.
1. Remove the Faceplate/bezel (A in FIG. 12) from the main NXD unit (B in FIG. 12) by gripping the
faceplate and pulling with gentle outward force.
#4-40 Mounting Screws
(four - included)
secure the NXD to
the Conduit Box
FIG. 12
Mounting Tab
B - Main NXD unit consists of
the touch panel and back box housing
A - Faceplate/Trim Ring
default Faceplate comes with buttons
C - Optional CB-TP7
conduit/wallbox
Stud