3.2 Setting the IP Address (When Using TCP/IP Protocol)
Setting subnetmask
address
3
Setting gateway
address
46
All manuals and user guides at all-guides.com
...from previous section
Press
once.
Press Set/Eject once.
Set the subnet mask in the same way as the IP address.
You can keep pressing
continuously when setting the value.
Press Cancel once. The screen returns to the screen
of the next lower level where "Subnet Mask" is displayed.
...from previous section
Press
once.
Press Set/Eject once.
Set up the gateway address in the way as the IP
address.
You can keep pressing
continuously when setting the value.
Once this value has been set, switch off the printer,
and then switch it on again.
or
to change the value
or
to change the value