Sekonic SPECTROMASTER C-7000 Startup Manual page 3

★ If Dark Calibration Position Confirmation screen appears, set the Light Selection
❷
Ring to Dark Calibration position and perform calibration again.
Dark Calibration Position
Confirmation Screen
Please set Light Selection
Ring for dark calibration.
NOTE
Dark calibration is performed when new batteries are set, 24 hours passed
since last use or there is a big change in temperature between turning power
OFF and ON again.
Except the cases above, dark calibration after power ON is skipped.
5. Measuring Mode and Display Mode
You can change screens after turning the power on as follows.
Changes from the Display Mode Selection Screen to the Measuring
Screen.
[
Display Mode
Selection Screen
(Page 1)
1
4
7
★ Pressing Menu Button
* If "Please set Light Selection Ring for dark
calibration" is displayed, set the Light
Selection Ring
position to start calibration.
* When taking measurements, set the Light
Selection Ring
the middle) for ALL ambient light.
For flash light, set the ring to "H" (icon
at the top) high-power (brighter than
640lx·s) flash or "L" (icon at the middle)
for low-power flash (lower than 640lx·s).
[
Display Mode
]
Selection Screen
(Page 2)
2
9
3
5
6

8
❻ shifts to the Display Mode Selection screen.
❷ to the dark calibration
❷
to the range L (icon at
[Measuring
Screen
]
(Text Mode)



[
Measuring Mode
]
Selection Screen
]