Table of Contents
Advertisement
Reasons for increased belt wear or defect
Belt contact the groove bottom / unequal set of belt / tension is too high or too low – Fig-
-
ure 130
Slippage / pulley too small / overloading / damaged disc / eccentricity, wobble – Figure
-
131
Disc worn / grooved not uniform / dust, dirt / moisture, humidity – Figure 132
-
Alignment / offset wheels / non-parallel plates / discs rotated to each other – Figure 133
-
Figure 130: Unfavourable operating conditions (1)
Figure 131: Unfavourable operating conditions (2)
Figure 132: Unfavourable operating conditions (3)
Figure 133: Unfavourable operating conditions (4)
Advertisement
Table of Contents
