Boss WAZA-AIR Using Manual page 84

REVERB Parameters
Parameter
TYPE
REVERB TIME 0.1 s–10.0 s
PRE DELAY
EFFECT
LEVEL
DIRECT MIX
LOW CUT
HIGH CUT
DENSITY
SPRING SENS
(TYPE =
SPRING only)
Value
Refer to REVERB Type
0 ms–500 ms
0–100
0–100
FLAT,
20 Hz–800 Hz
630 Hz–
12.5 kHz,
FLAT
0–10
0–100
Explanation
Adjusts the length (time) of
reverberation.
Adjusts the time until the
reverb sound appears.
Adjusts the volume of the
reverb sound.
Adjusts the volume of the
direct sound.
This sets the frequency
at which the low cut filter
begins to take effect. When
"Flat" is selected, the low
cut filter will have no effect.
This sets the frequency at
which the high cut filter
begins to take effect. When
"FLAT" is selected, the high
cut filter will have no effect.
Adjusts the density of the
reverb sound.
Adjusts the sensitivity of
the spring effect. When
the value is set higher, the
effect is obtained even with
a weak picking.
84