Compare the illustrations with your generator to familiarize yourself with the locations of various
controls and product warnings.
CO Guard™
Carbon Monoxide
(CO) Shutdown
Indicator Light
Start
Switch
Hour Meter
Rocker Switch
Circuit Breaker
Low Oil
Circuit Breakers
Shutdown
120 Volt AC, 20 Amp, GFCI Duplex Receptacles — Used
to supply 120 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads.
120/240 Volt AC, 30 Amp Locking Receptacle — Used to
supply 120 / 240 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads.
Circuit Breakers (AC) — The 120 Volt AC, 20A GFCI duplex
receptacles are provided with "push to reset" 20 Amp circuit
breakers to protect the generator against electrical overload.
CO Guard™ Carbon Monoxide (CO) Shutdown Indicator
Light — Indicates the engine shutdown due to carbon
monoxide accumulation around the generator or a CO
Guard system fault occurred.
120/240 Volt AC, 30 Amp
Locking Receptacle
120 Volt AC, 20 Amp
GFCI Duplex Receptacles
Features and Controls
Hour Meter — Displays and records how many hours your
generator has run (up to 9,999.9).
Low Oil Shutdown — This unit is equipped with a low oil
protection device. Oil must be at proper level for engine
to run. If the engine oil drops below a preset level, an oil
switch will stop the engine. Check oil level with dipstick.
Rocker Switch Circuit Breaker — The 30 Amp locking
receptacle is provided with a 2 pole rocker switch circuit
breaker to protect the generator against electrical overload.
Start Switch — Turn key to START position to start engine.
Turn key to OFF position to switch off engine.
EN5