Peripheral Setup - American Megatrends Titan III User Manual

Peripheral Setup

Peripheral Setup options are displayed by choosing the Peripheral Setup icon
from the WINBIOS Setup main menu. All Peripheral Setup options are
described in this section.
Onboard Floppy Controller Set this option to Enabled to enable the floppy drive controller
on the motherboard. The settings are Auto (AMIBIOS automatically
determines if the floppy controller should be enabled), Enabled, or Disabled.
The Optimal and Fail-Safe default settings are Enabled.
Onboard Primary/Secondary IDE This option specifies the IDE channel that is used on the
onboard IDE controller. The settings are:
Setting
The onboard IDE controller is not used.
Disabled
Primary The primary channel on the onboard IDE controller is used.
Secondary The secondary channel on the onboard IDE controller is used.
Both Both the primary and secondary channels on the onboard IDE
controller is used.
The Optimal and Fail-Safe default settings are Disabled.
Onboard IDE Bus Master Set this option to Enabled to specify that the onboard IDE device
on the PCI local bus has bus mastering capability. Short J4 and J30 on the
motherboard when this option is set to Enabled. When J4 and J30 are
shorted, PCI Slot 4 is in slave mode only. Non-bus mastering PCI adapter
cards (such as a VGA card) can then be installed in PCI Slot 4 without using
a PCI bus mastering slot.
The settings are Disabled or Enabled. The Optimal and Fail-Safe default
settings are N/A.
52 Titan III PCI EISA Motherboard User's Guide
Description
Cont'd