Table of Contents
Advertisement
AMIFlash,
Continued
Enter the filename with which Flash EPROM will be reprogrammed (S701P.ROM). AMIFlash reads the file and
displays a startup message. A Press any key to continue. After Flash programming starts, programming activity is
indicated by a rotating / character. AMIFlash informs you when Flash programming is successful (as shown below).
Press any key to reboot the system.
Errors During Flash Programming
If an error occurs during programming, an error messages is displayed and the system halts. Turn power off and
replace the Flash EPROM with a new programmed Flash EPROM to make the system usable.
AMIFlash Messages
Excalibur PCI Pentium ISA Motherboard User's Guide
Message
Save Existing BIOS ?
Press Y to save the existing BIOS.
Enter Filename:
Enter the filename in which the existing BIOS will be
saved in the following format:
and press <Enter>.
Enter BIOS Filename:
Enter the filename with which the Flash EPROM will be
programmed in the following format:
and press <Enter>.
Programming Flash
Displayed when the Flash EPROM is being programmed.
EPROM
Saving BIOS File in
Displayed when the existing BIOS is saved to disk.
Disk
Reading BIOS File
Displayed when the file with which Flash EPROM will be
from Disk
programmed is being read from the disk.
Press <ESC> to Exit
When this message is displayed, you can exit AMIFlash
by pressing <Esc>.
Press Any Key to Exit
Usually displayed below another message when a fatal
error occurs, for example, no Flash EPROM present in
system or the hardware is not accessible.
Press Any Key to
Displayed after successful Flash EPROM programming.
ReBoot
Want to Continue?
Displayed after an error message.
Want to Exit (Y/N)?
Displayed when you press <Esc>.
Please Wait..
Displayed when Flash programming is occurring.
Explanation
Drive:\Pathname\Filename.Ext
Drive:\Pathname\Filename.Ext
91
Advertisement
Table of Contents
