Installation Steps; Step 1 Set Switches And Jumpers - American Megatrends Excalibur PCI User Manual

Installation Steps

Step 1 Set Switches and Jumpers

Set all user-configurable jumpers and switches before installing the motherboard in the chassis. There are two
user-configurable switches and two jumpers:
SW1 Multipurpose switch
J2 Parallel Port IRQ Select
J3 Enhanced Parallel Port DMA Select Request
J5 Enhanced Parallel Port DMA Select Acknowledge
J4 Select Password LED
J6 Flash BIOS Programming Voltage
P24 Select SCSI Interrupt
Chapter 4 Installation
20
This motherboard contains sensitive electronic components which
can be easily damaged by static electricity. Follow the instructions
carefully to ensure correct installation and to avoid static damage.
Step
1 Set switch and jumper options
2 Install memory
3 Install motherboard
4 Connect the power supply
5 Connect the keyboard
6 Connect the mouse
7 Connect cables
8 Connect onboard I/O
9 Install floppy drive
10 Install hard disk drive
11 Install adapter cards
12 Test and configure
Warning
Action Turn to
Page 20
Page 24
Page 38
Page 39
Page 41
Page 42
Page 42
Page 46
Page 51
Page 51
Page 53
Page 47