Display Information About The Lan Port, Access Point, And Wifi Settings [Access Point Mode] - NETGEAR WAX204 User Manual

Wifi 6 ax1800 dual band wireless access point
Hide thumbs Also See for WAX204:
Table of Contents

Advertisement

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
(Continued)
Field
Mode
Wireless AP
Broadcast Name
Wi-Fi Protected Setup
Display information about the LAN port, access point, and
WiFi settings [access point mode]
If the access point is in access point mode, you can display information about the LAN
IP addresses, access point, and the WiFi settings for each radio.
To display information about the access point and the IP and WiFi settings if the
access point is in access point mode:
1. Launch a web browser from a computer or mobile device that is connected to the
access point network.
2. Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
Maintain and Monitor
Description
The WiFi throughput mode that the radio uses (see Change the WiFi throughput
mode for a radio on page 194).
Displays if the WiFi network is enabled (see Set up or change an open or secure
WiFi network on page 59 or Enable or disable a WiFi network on page 65).
Displays if the WiFi network broadcasts its SSID (see Hide or broadcast the SSID
for a WiFi network on page 66).
This setting applies to the Wireless 1 network only.
Displays if WPS is enabled.
Note: If you either set up open security for the Wireless 1 network or disable the
WiFi radios, WPS is disabled.
149
User Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents