Disable Led Blinking Or Turn Off Leds - NETGEAR WAX204 User Manual

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204

Disable LED blinking or turn off LEDs

The LEDs on the top panel of the access point indicate activities and behavior. By default,
the Internet LED, LAN LED, and WiFi LED blink when the access point detects data traffic.
You can disable LED blinking for data traffic, or turn off all LEDs except the Power LED.
To disable LED blinking or turn off the LEDs:
1. Launch a web browser from a computer or mobile device that is connected to the
access point network.
2. Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > LED Control Settings.
The LED Control Settings page displays.
By default, the first radio button is selected, which allows standard LED behavior.
For more information about LEDs, see Top panel with LEDs on page 11.
5. To disable blinking, select the Disable blinking on Internet LED, LAN LED, Wireless
LED when data traffic is detected radio button.
6. To turn off all LEDs except the Power LED, select the Turn off all LEDs except Power
LED radio button.
7. Click the Apply button.
Your settings are saved.
Maintain and Monitor 166 User Manual