Add, Remove Or Change A Device On The The Allowed List - NETGEAR WAX204 User Manual

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
c. In the Device Name field, change the name.
d. Click the Apply button.
The Access Control page displays again.
9. Click the Apply button.
Your settings are saved.
10. To refresh the information in the table with currently connected devices, click the
Refresh button.
The table shows the status of the device (allowed or blocked from future sessions),
device name, IP address, MAC address, and type of connection to the access point.

Add, remove or change a device on the the allowed list

If you set up an access list that blocks all new devices from accessing your network, you
must set up an allowed list that defines which WiFi and wired devices are allowed to
access your entire network. You do so by adding the MAC addresses of these devices
to the allowed list. You can also change or remove a device from the allowed list.
To add, remove, or change a device on the allowed list:
1. Launch a web browser from a computer or mobile device that is connected to the
access point network.
2. Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Security > Access Control.
The Access Control page displays.
Security, Firewall, and Access
Rules
83 User Manual