How To Remove The Tilt Motor - American Dynamics SpeedDome Ultra Installation And Service Manual

How to Remove the Tilt Motor

1. Perform the procedure "How to Remove the
Slot Covers".
2. Perform the procedure "How to Remove the
Camera".
3. Perform the procedure "How to Detach the
Eyeball From the Housing".
4. Separate the yoke brackets (Figure 4-16).
Figure 4-16.
5. Gently pry off yoke bracket covering the pan
gear assembly to access the tilt cable
assembly (Figure 4-17).
Figure 4-17.
6. Access the tilt motor.
To do this, loosen the captive retaining screw
holding the tilt cable assembly in place and gently
remove this assembly.
7. Remove the tilt motor (Figure 4-18).
Lift the motor housing up as shown (1) to disengage
the motor from the tilt gear. Then pull the motor
bracket towards the outside of the cable/tilt assem-
bly (2) to remove the motor.
Figure 4-18.
Reverse steps to reassemble.
SPEEDDOME ULTRA
4-10
Tilt Motor
(Lift up,
then out)
When putting in a new motor, be careful
to properly mesh the motor and tilt
gears!
Failure to do so can destroy both the motor
and tilt gear. Verify that the tilt gear turns
freely!
SERVICE