Meyer Sound LEO Series Assembly Manual page 17

2. Attach the MRK-750 end frames and the previously removed grille frame:
Figure 2: Installing MRK-750 end frames and grille
Use a torque wrench to secure the MRK-750 end frames to the cabinet with the eight 1/4-20 x 1.5-inch button head
•
screws (PN 101.744) (four top and four bottom). Apply one or two drops of Loctite to each of the button head screws
before installing them.
For all-weather, outdoor installations, use the silver weather-protected button head screws
NOTE:
(PN 101.244).
Make sure the screws are securely tightened but do not over-tighten them. Approximately
CAUTION:
!
40 inch-pounds of torque is recommended.
Use a Phillips screwdriver to secure the handles to the end frames, reusing the eight 1/4-20 x 2-inch flathead screws
•
(four each side) removed earlier. Apply one or two drops of Loctite to each of the flathead screws before installing them.
Approximately 40 inch-pounds of torque is recommended.
Use a Phillips screwdriver to secure the grille frame to the cabinet with the six 10-32 x 1.75-inch flathead screws (three
•
each side). Apply one or two drops of Loctite to each of the flathead screws before installing them.
MG-MINA/LINA/750-LFC GRID ASSEMBLY GUIDE
9