Table of Contents
Advertisement
5
S ecure the housing to
a strong structural
ceiling member.
B
Run the chain up into
the ceiling and wrap it
around a structural
member above the
housing.
C
Keep the chain taught
as possible. Do not
sec ure the housing to
Attach the end of the
a fire c ontrol system.
chain to itself using
another S -hook. Close
the ends of the S -hook.
S
A
Attach an S -hook to
safety chain supplied,
then attach the S -hook
to the housing. Close
the ends of the S -hook.
6
S ecure the housing to
the ceiling.
A
Insert housing.
C
B
T urn each of the four
locking screws clockwise
to seat the "swing out"
mounting clips tightly
against the c eiling.
P ower the dome (heater fans turn on).
T he camera lens then follows a pattern
until it reac hes its home position. T he
controller c an then be used to c all up
and control the dome.
If OK, continue. If not, see
"T roubleshooting" in information
attac hed.
Green, red, and yellow LEDs will light in
various patterns to indicate status.
T ypically, these LEDs do not need to be
viewed unless a failure oc curs. S ee
"T roubleshooting" in information
attac hed for an explanation
Of the LED patterns.
7
Attach the bubble
to the housing.
A
Place the large hole in the
end of the lanyard over the
screw head on the bubble.
P ull the end of the lanyard to
the inside of the bubble to
snap it in place.
C
T urn the bubble c loc kwise
until it c atc hes the tabs and
stops.
P age 2 of 18
B
Align tabs in the
bubble with mating
tabs in the housing.
8000-2692-01, R ev. E
Advertisement
Table of Contents
