Video Input Module - American Dynamics AD2052 Installation And Operating Instructions Manual

SETUP
Video Input Module Switches
The 2016AVIM (Video Input Module) performs the actual
video switch. Each module can switch any one of 16 video
inputs to any video output, or multiple combinations of video
outputs, up to 16.
The 2016A Video Input Module must be set to the cameras and
monitors it is to respond to. There are two 8-position dip
switches. DIP switch S1 is used to set all field configurations.
The eight position dip switch S1, located on the circuit board,
must be set to identify the camera and monitor group. The first
two switches select one of four groups of 16 monitors and the
last six select one of 64 groups of 16 cameras. Switch settings
are shown in Table 3.
The monitor group selection is independent of the camera
group selection. Yet both monitor and camera group must be
selected correctly depending on the particular slot the card is
being placed in. Note: The silkscreen on the board clearly
shows the correct dip switch to use. The word "CAM GRP" is
screened adjacent to the correct dip switch.
The DIP switch S3 is not used in this module.
S1
8 1
S3
Figure 27 - Video Input Module Card Jumper Switches
Table 3 - S1 Camera and Monitor Identification
1=On; 0=Off; X=Don't care
Monitors 1
1- 16 0
17- 32 0
33- 48 1
49 - 64 1
65- 80 0
81- 96 0
97 - 112 1
113 - 128 1
Camera
1-16 X
17-32 X
33-48 X
49-64 X
65-80 X
81-96 X
97-112 X
113-128 X
129-144 X
145-160 X
161-176 X
177-192 X
14
Switch Positions
2 3 4 5 6 7
0 X X X X X
1 X X X X X
0 X X X X X
1 X X X X X
0 X X X X X
1 X X X X X
0 X X X X X
1 X X X X X
X 0 0 0 0 0
X 0 0 0 0 0
X 0 0 0 0 1
X 0 0 0 0 1
X 0 0 0 1 0
X 0 0 0 1 0
X 0 0 0 1 1
X 0 0 0 1 1
X 0 0 1 0 0
X 0 0 1 0 0
X 0 0 1 0 1
X 0 0 1 0 1
8
X
X
X
X
X
X
X
X
0
1
0
1
0
1
0
1
0
1
0
1