Video Output Module 2024Vom - American Dynamics AD2052 Installation And Operating Instructions Manual

Video Output Module - 2024VOM
The 2024VOM (Video Output Module) creates the titles that
are added to the video output. Each module has four video
outputs on its rear panel.
Front Panel
Front panel controls on the Video Output Module adjust the
brightness, vertical, and horizontal position for each title
displayed on each of the four video outputs. The 4-position
rotary switch on the front panel governs which output you
control. The front panel LED blinks to verify proper operation
of the 2024VOM. See Figure 20 below. Further details on
operation of these controls is provided in the Video Output
Module SETUP description, page 17.
D
.
.
A
H
V
B
Video Output Module
Front Panel Indicators and Controls
Blinking LED for proper operation
4-position rotary switch
Horizontal control push button
Vertical control push button
Brightness control push button
Figure 20
SYSTEM MODULES DESCRIPTION
Rear Panels
The 2024VOM-1 rear panel, as seen in Figure 21, has 16 BNC
connectors. The bottom four BNCs are video outputs while
the remaining upper three groups, each containing four BNCs,
are for video inputs from other matrix switching bays in the
system.
The 2024VOM-2 rear panel, as seen in Figure 22, has four
sections of four BNCs for video inputs from other matrix
switching bays. A fifth section of four BNCs, in the lower left
corner, is used for video outputs.
1
4
1
4
1
4
1
O
U
T
4
Figure 21
Video Output Module
2024VOM-1
Rear Panel
9
1
4
1
4
1
4
1 1
O
U
T
4 4
Figure 22
Video Output Module
2024VOM-2
Rear Panel