A.11
www.eltra-trade.com
Sensor characteristics
1)
Error status (level or number) on an output is updated only at the time the error status changes
(occurs or disappears). If P40 is suppressed after it has been detected (at power up), the
output does not change state. In this case the power must be switched off/on to suppress the
P40 error on the output.
2)
The frequency can be set to 44 Hz in the MAG 6000 SV transmitter only.
info@eltra-trade.com
Menu diagrams
A.11 Sensor characteristics
81
+421 552 601 099