Installation
Keyboard
RS485-RS232 Converter
RS232-USB Converter
•
The RS485 data lines from the keyboard's KMI terminals would go through the RS485-RS232 converter, the
RS232-USB converter, and then the USB port of DigiMux. Note that the RS485-RS232 requires 12VDC.
•
Domes are connected directly to RS485 terminals on the DigiMux external I/O board, using RS485.
Setup and Configuration
•
Keyboard setup:
•
RS485 at 19200 BAUD
•
Number of Retries: 0
•
Time out 60 seconds.
Refer to the ControlCenter 200/300 Keyboard Installation and Operation manual for instructions.
•
In the DigiMux OSD menu, select:
•
Keyboard: CC/RS485
•
USB Port: front, rear-left, or rear-right. Rear port is recommended (save your front port for the USB flash
drive).
•
Keyboard USB Baudrate: 19200
•
RS485 Port Settings: corresponds to the type of dome used: 4800-8-1-None for AD domes.
•
Dome protocol: set the correct dome protocol and ID.
•
Reboot your DigiMux after the setup to allow the operating system to recognize new device.
Operation Information
•
DigiMux control is available form the keyboard. Use the DigiMux RS485 Unit Address as the destination of the
keyboard.
•
Dome control is available from the ControlCenter keyboard.
•
Dome control is also available from:
•
DigiMux front panel,
•
Remote DigiClient, and
•
DigiRemote.
Call Monitor Control
You can see the DigiMux front panel or the ControlCenter 200/300 keyboard to control a call monitor display without
having to access the DigiMux main menu.
From the Front Panel:
1. Press and hold ESCAPE and MODE for 3 seconds. The mode button starts flashing to indicate that the front panel
is in Call Monitor Control mode.
2. Press any CAMERA button to display the associated camera on Call monitor's output.
3. Press SEQUENCE. The SEQ LED flashes and the Call Monitor displays the sequence of cameras previously
programmed in Call Monitor Schedule menu.
4. Press ESCAPE to return the front panel to Main monitor control mode.
From the ControlCenter 200/300 keyboard:
1. Select monitor #2 on the ControlCenter 200/300 keyboard. DigiMux switches to Call Monitor Control mode.
2. Select a camera to display a camera, or select a sequence to display a programmed sequence of cameras on the
Call Monitor.
DigiMux User's Manual Addendum
© 2005 Sensormatic Electronics Corporation
+12Vdc
RS-485
19200 Baud
KMI
8200-0494-9900 A1
Dome
+12Vdc
DigiMux
RS-485
4800 Baud
4