Keyboard Setup Menu Defaults:
Selecting a Keyboard Protocol
Select the protocol that matches your keyboard configuration:
None
CC/RS485
CC/RS232
ADTT16
Entering USB Settings
Selecting the keyboard protocol activates the second menu item, USB Port. Specify which USB port, Front, Rear-Left,
or Rear-Right is to be used with the keyboard. If a USB port is not displayed, it may already be assigned to another
device such as a modem, etc.
Selecting a USB port activates the third menu item, Keyboard USB Baud Rate. Select the baud rate that matches the
keyboard connection: 2400 (default), 4800, 9600, or 19200. There is no baud rate selection for ADTT16.
ADTT16E Touch Tracker Use with DigiMux
DigiMux supports the use of the ADTT16E Touch Tracker as an American Dynamics dome control device. You can
use the Touch Tracker to control domes directly through Sensornet, or control domes from the DigiMux front panel or
remote DigiClient software. The Touch Tracker also can call up single or multi-screen live displays on the DigiMux
main monitor.
If your DigiMux configuration is:
Then you do not need to perform any updates.
Hardware Requirements
RS232-USB converter. Use ADACUSBCVT1 or one of the following models:
•
BT-DB925, Bytecc, Inc.
•
USB-GMUS-03, Bytecc, Inc.
•
UC232A, ATEN International, Inc.
•
GUC232A, I/O Gear, Inc.
Software Requirements
Install the new software provided with your USB flash drive, or download the software from the Internet. See the
DigiMux Software Update Instructions.
After the update, your DigiMux should have:
DigiMux User's Manual Addendum
© 2005 Sensormatic Electronics Corporation
1
Keyboard Protocol
2
USB Port
3
Keyboard USB Baud rate
No keyboard setup (default)
ControlCenter 200/300 Keyboard using RS485
ControlCenter 200/300 Keyboard using RS232 (future use)
Touch Tracker ADTT16 Keyboard setup (see
Keyboard Setup Menu
Software Version:
Software Version:
8200-0494-9900 A1
Keyboard Setup
on page 1)
1.0.6.20-16 (or newer)
1.0.6.20-16 (or newer)
None
None
2400
Using the
2