Subaru WRX STI S209 Supplement Manual page 19

the sealant, allergy symptoms
may occur.
1) Expiration date
CAUTION
Replace the sealant bottle with a
new one before the expiration date
passes.
! How to seal the flat tire
To seal the flat tire, perform the following
steps.
. First, pump in the sealant and air. Drive
the vehicle for approximately 10 minutes
or 3 miles (5 km) so that the sealant can
seal the damaged area.
. Stop the vehicle again, check and, if
necessary, adjust the pressure of the
damaged tire.
. After that, you can continue to drive
carefully no faster than 50 mph (80 km/h)
and within the maximum distance of 125
miles (200 km).
Inform all other users of the vehicle that
the tire has been temporarily sealed with
the flat tire repair kit and make them
aware of the special driving conditions to
be observed.
1. Shake the sealant bottle well. Loosen
the hose.
1) Valve
2. Connect the air compressor hose to
the valve on the bottle.
CAUTION
. Make sure that the air compres-
sor switch is OFF.
. The sealant may leak if the fitting
is not tight enough.
15