Subaru WRX STI S209 Supplement Manual page 13

same position for the desired
angle.
. Do not loosen the nuts and bolts
on the front side.
1) Front of vehicle
1. While holding the bolt on the rear side
with a TORX® wrench, use a wrench,
socket wrench and socket, or a similar
tool to remove the nut and washers.
1) Front of vehicle
2. Remove the bolt and washers.
1) Front of vehicle
A) Standard position
B) High downforce position
3. Adjust the angle of the rear wing. We
recommend that you adjust the angle to
the standard position for attaining both
stability at high speed and enhanced
handling.
1) Front of vehicle
4. Install the bolt and washers. While
holding the bolt with a TORX® wrench,
use a wrench, socket wrench or a similar
tool to install the washers and nut and to
tighten the nut.
Tightening torque:
2.2 lbf·ft (3.0 N·m, 0.31 kgf·m)
! After adjusting the angle
WARNING
Make sure that the bolts and nuts
are tightened securely. If they are
9