Solutions When The Image Contains Noise Or Static; Solutions When The Image Is Fuzzy Or Blurry - Epson Home Cinema 2200 User Manual

Solutions When the Image Contains Noise or Static

If the projected image seems to contain electronic interference (noise) or static, try the following
solutions:
• Check the cables connecting your computer or video source to the projector. They should be:
• Separated from the power cord to prevent interference
• Securely connected at both ends
• Not connected to an extension cable
• No longer than 24 feet (7.3 m) for HDMI cables
• Try decreasing the Sharpness setting in the Image menu.
• Try adjusting the Noise Reduction or MPEG Noise Reduction setting in the Image menu.
• Check the settings on the projector's Signal menu to make sure they match the video source.
• Select a computer video resolution and refresh rate that are compatible with the projector.
• If you connected an extension power cable, try projecting without it to see if it caused interference in
the signal.
Parent topic:
Related references
Input Signal Settings - Signal Menu
Image Quality Settings - Image Menu
Supported Video Display Formats

Solutions When the Image is Fuzzy or Blurry

If the projected image is fuzzy or blurry, try the following solutions:
• Adjust the image focus.
• Clean the projector lens.
Note: To avoid condensation on the lens after bringing the projector in from a cold environment, let the
projector warm up to room temperature before using it.
• Position the projector close enough to the screen.
• Position the projector so the keystone adjustment angle is not so wide that it distorts the image.
• Turn on automatic keystone adjustment in the projector's menus.
Solving Image or Sound Problems
105