Solving Image Or Sound Problems - Epson Home Cinema 2200 User Manual

Power light
Off
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.
Parent topic:
Related tasks
Cleaning the Air Filter and Vents
Replacing the Air Filter
Replacing the Lamp

Solving Image or Sound Problems

Check the solutions in these sections if you have any problems with projected images or sound.
Solutions When No Image Appears
Solutions When "No Signal" Message Appears
Solutions When "Not Supported" Message Appears
Solutions When Only a Partial Image Appears
Solutions When the Image is Not Rectangular
Solutions When the Image Contains Noise or Static
Solutions When the Image is Fuzzy or Blurry
Status light Lamp light Temp light
Flashing blue Off
Solving Problems
Status and solution
Orange Projector has overheated and
turned off; leave it turned off to cool
down for about five minutes, then do
the following:
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects
• Clean or replace the air filter
• If operating the projector at high
altitude, turn on High Altitude
Mode
• If the problem persists, unplug the
projector and contact Epson for
help
100