Displaying Signal Information; Updating Software - Grundig 22 VLC 2000 T Manual

INFORMATION
Displaying­signal­information
(only for digital television channels)
1 Open the menu with »M«.
– T he »PICTURE« menu appears.
2 Select the menu »CHANNEL SETUP« with
» « or » «.
r e
3 Select »Signal Information« with »
and press »OK« to confirm.
– Y ou will see information on the channel,
modulation, quality and signal strength.
Notes:
The lower section of the menu shows the
7
signal properties. The further the bar for
»quality« and »Signal Strength« extends to
the right, the better the reception signal.
The signal level not only depends on your re-
7
ceiver system, but also on the channel which
is currently active. Remember this when
aligning your antenna using the signal level
display.
4 Press »M« to end the display.
Automatic­software­update
(Only for digital television channels)
If this function is enabled, the device automati-
cally searches for new software and updates it if
a new version is available.
1 Select the line »Automatic Update« with »
or » « and confirm using »OK«.
w
2 Press »
« or » « to switch the function on or
r e
off.
3 Press »M« to end the setting.
34­
ENGLISH
­ - -----------------------------------------------------------------------------------------------------------------
Updating­software
(only for digital television channels)
1 Open the menu with »M«.
– T he »PICTURE« menu appears.
2 Select the »OPTIONS« menu with »
»
3 Select the »Software Update« menu by press-
« or » «
q w
ing »
4 Press »OK« to start the software update.
– The software is updated automatically, if
possible.
5 Press »M« to end the setting.
«
q
«.
e
« or » «.
q w
« or
r