Before Use; Fitting/Changing The Saw Blade; Connecting The Sawdust Extractor; Checking Blade Guard Functionality - Parkside PTSS 1200 C2 Original Instructions Manual

Before use

Fitting/changing the saw blade

Always remove the plug from the power socket
before working on the appliance.
NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
1. Activate the safety lock-out
motor unit forwards a little way.
2. Open the clamping lever
Then push the motor unit
hear the lock click into place. Release the safety
lock-out . The movement of the motor unit is
blocked upward and downward.
3. The clamping screw/washer
in the cut-out .
14
b
4. Press the spindle lock button
engages) and use the hex key
the clamping screw/washer
5. Remove the saw blade
NOTE
► Ensure that the factory-fitted flange X stays
in place during installation and removal
(see fig. A).
Fig. A
6. To fit a saw blade
in reverse order.
WARNING!
► The direction of rotation of the saw blade
and the machine must match.
│ GB │ IE
■ 8
and push the
.
forward until you
is now located
14a
(until it
to release
.
14a
.
, carry out the above steps

Connecting the sawdust extractor

♦ If required, attach the chip ejector adapter for
dust extraction
♦ Connect an approved dust and chip extraction
device.

Checking blade guard functionality

NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
♦ Activate the safety lock-out
circular saw.
♦ Check whether the saw blade
the blade guard and whether it moves back to
its starting position automatically.

Use

Switching on and off
Switching on
♦ Push the safety lock-out
in position.
♦ Press the ON/OFF switch
running, you can release the safety lock-out
Switching off
♦ Release the ON/OFF switch
X
to the chip ejector .
and lower the
rubs against
upwards and hold it
. Once the saw is
.
PTSS 1200 C2
.