Table of Contents
Advertisement
Packaging
Transport
Transport inspection
Storage
SITRANS LVL200S l RELAY (DPDT)
3.3 Operation
With the factory setting, products with a density > 0.07 g/cm³
(0.025 lbs/in³) can be measured. The instrument can be
adapted if products with lower density should be measured.
On the electronics module you will find the following indicating
and adjustment elements:
Signal lamp for indication of the switching condition (green/
l
red)
DIL switch for sensitivity adjustment
l
Mode adjustment for selection of the switching condition
l
(A/B)
3.4 Storage and transport
Your instrument was protected by packaging during transport.
Its capacity to handle normal loads during transport is assured
by a test according to DIN EN 24180.
The packaging of standard instruments consists of environ-
ment-friendly, recyclable cardboard. In addition, the sensor is
provided with a protective cover of ABS. For special versions
PE foam or PE foil is also used. Dispose of the packaging
material via specialised recycling companies.
Transport must be carried out under consideration of the notes
on the transport packaging. Nonobservance of these instruc-
tions can cause damage to the device.
The delivery must be checked for completeness and possible
transit damage immediately at receipt. Ascertained transit
damage or concealed defects must be appropriately dealt
with.
Up to the time of installation, the packages must be left closed
and stored according to the orientation and storage markings
on the outside.
Unless otherwise indicated, the packages must be stored only
under the following conditions:
Not in the open
l
Dry and dust free
l
Not exposed to corrosive media
l
Protected against solar radiation
l
Avoiding mechanical shock and vibration
l
Product description
9
Advertisement
Table of Contents
