Stroke Setting & Adjustment (Fig 3) - Stanley Avdel NeoBolt PB2500N Instruction And Service Manual

E N G L I S H
Note: DO NOT use spanners to mount Collet (A) onto Front Clutch (Q). Manual tightening of Collet (A) is enough to
lock onto Front Clutch (Q)
3.3 STROKE SETTING & ADJUSTMENT (FIG 3)
3.3.1 INITIAL STROKE SETTING
• Determine Application pin stick out length in millimeters ("L" in fi gure below).
• Remove battery pack from tool.
• Remove Nose Housing (C) and Collet (A) to expose the Stroke Adjustment Pin (N).
• Set the Stroke Adjustment Pin (N) to fl ush with Pulling Head Adapter (P).
• Rotate the Stroke Adjustment Pin (N) clockwise (CW) according to the following:
• Mount the Nose Housing (C) and Collet (A) and tighten the Nose Housing Nut (D).
• Verify setting by installing NeoBolt® in Application Grip.
Length (L)
15mm
16mm
17mm
18mm
19mm
20mm
21mm
22mm
23mm
3.3.2 STROKE ADJUSTMENT (FIG 3 & 4)
• Remove battery pack from tool.
• Insert 2.0mm Hex Key (BB) into front of the tool through the hole in the Collet Stop (Z).
• Adjust the tool stroke by rotating the Stroke Adjustment Pin (N) to achieve the desired NeoBolt®
installation. (Ref. Fig. 4)
• Each rotation of the Stroke Adjustment Pin (N) changes tool stroke by 1mm (0.04")
• To increase the stroke, rotate Stroke Adjustment Pin (N) counter-clockwise (CCW).
• To Reduce the stroke, rotate Stroke Adjustment Pin (N) clockwise (CW).
• Verify setting by installing NeoBolt® in Application Grip.
• Repeat adjustment as needed.
18
Note: Stroke Adj.
pin set fl ush to
pulling head
Pin Adjustment (Number of Rotations)
10 full rotations (CW)
9 full rotations (CW)
8 full rotations (CW)
7 full rotations (CW)
6 full rotations (CW)
5 full rotations (CW)
4 full rotations (CW)
3 full rotations (CW)
2 full rotations (CW)