Table of Contents
Advertisement
3. INSTALLATION INSTRUCTIONS
3.1 Unpack the absorption minibar
WARNING
3.1.1 Remove the Packaging
• Remove tape and glue residue from surfaces before turning on the absorption minibar. Rub a small
amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape
or glue. These products can damage the surface of your absorption minibar. For more information,
see "en."
• On some models, shelves, bins, door shelf rails, and other feature parts may be packaged in the
Interior FeaturePak. Follow the instructions contained in the package for proper assembly.
• Properly dispose of packaging.
When Moving Your absorption minibar:
• Your absorption minibar is heavy. When moving the absorption minibar for cleaning or service, be
sure to protect the floor.
• Always pull the absorption minibar straight out when moving it.
• Do not wiggle or "walk" the absorption minibar when trying to move it, as floor damage could occur.
3.1.2 Clean Before Using
After you remove all of the package materials, clean the inside of your absorption minibar before using
it. See the cleaning instructions in "6. ABSORPTION MINIBAR CARE".
Important information to know about glass shelves and covers:
Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may
break if exposed to sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter into many small, pebble-size pieces. This is
normal. Glass shelves and covers are heavy. Use special care when removing them to avoid impact
from dropping.
6
Instructions for the Installer
Excessive Weight Hazard.
Use two or more people to move and install refrigerator.
Failure to do so can result in back or other injury.
Advertisement
Table of Contents
