Table of Contents
Advertisement
2-2. Removing/Reattaching the
PTZ Camera (SNC-RZ30NB)
Removal
1. Remove the louver. (Refer to Section 1-2-1.)
2. Loosen the four screws, and remove the
upper case assembly.
3. Disconnect the harness from the connectors
(CN12, CN13, and CN15 to CN17) on the
PS-699 board.
4. Remove the harness from the two clamps.
5. Disconnect the harness from the connectors
(CN2, CN14, and CN18) on the PS-699
board.
6. Disconnect the harness from the connectors
(CN3, CN13, and CN14) on the SNT-1
board.
7. Remove the four screws, and remove the PTZ
camera assembly.
2-2 (E)
C5 x 20
PS-699 board
Lower case
assembly
CN16
PSW4 x 10
PS-699
board
PTZ camera
assembly
*: CN2/PS-699 board is mounted on the lower side (side B) of the unit
(Serial No. 10001 to 10005).
Upper case assembly
CN13
CN12
CN17
Clamp
*
CN3
CN14
CN13
CN2
SNT-1
CN18
C5 x 20
CN15
Clamp
CN14
board
XIS-10DC
Advertisement
Table of Contents
