Step 3- Table Brace Assembly - Bernina Quilting Frame Assembly Instruction Manual

Note: If setting up in crib attach to outside holes as shown in
Fig. 2-1B
2-2: Attach the other side of the Track Support to the inside
holes on the front side of the Middle Leg with (4) M6 x 10mm
SBHCS, as shown in Fig 2-1A.
2-3: Attach another Track Support to the outside holes on the
back side of the right leg stand with (2) M6 x 10mm SBHCS.
2-4: Attach the other side of the back Track Support to the
inside holes on the Middle Leg with (2) M6 x 10mm SBHCS.
2-5: Now attach (2) Track Supports to the outside holes on the
other Side Leg and the remaining holes on the Middle Leg using
(8) M6 X 10mm SBHCS, as shown in Fig. 2-2.
Step 3: Table Brace Assembly
Parts Needed:
4- Table Brace
4- M6 x 15 mm SBHCS
4- M6 x 35 mm SBHCS
4- M6 Nylock Nut
1- Middle Leg
2- Side Leg
Tools Required:
4mm Allen Wrench
Open End Wrench
3-1: Attach (2) Table Braces to right side
of the frame using (2) M6 x 15mm SBHCS, as shown in Fig 3-1,
making sure not to fully tighten.
3-2: Connect (2) Table Braces to the Tack Support by lining the holes up with
the slots on Tack Support, placing (2) M6 x 35mm SBHCS through the holes
and tighten it down with (2) M6 Nylock Nuts.
3-3: Repeat Steps 3-1 and 3-2 for the left side of the frame.
3-4: Tighten the M6 x 15mm SBHCS on the (4) Table Braces.
M6 X 10mm
Left Side
Track Support
M6 Nylock
Nut
M6 X 35mm
SBHCS
Table Brace
Fig. 2-1B
M6 x 10mm
SBHCS
Long Leg
Side Leg
Crib Assembly
SBHCS
Track Support
Middle Leg
M6 X 15mm
SBHCS
Short
Leg
Fig. 2-2
Fig. 3-1
Pg.6