Step 1- Height Adjustable Leg Assembly; Step 2- Track Support Assembly - Bernina Quilting Frame Assembly Instruction Manual

Step 1: Height Adjustable Leg Assembly
Parts Needed:
6- Leveling Foot(pre-installed)
6- M8 x 55mm SBHCS(pre-installed)
6- M8 Washer(pre-installed)
6- M8 Nylock Nut(pre-installed)
1- Middle Leg
2- Side Leg
Tools Required:
5mm Allen Wrench
Open End Wrench
Height of Fabric Surface
Top Hole 45"
9th Hole
44"
8th Hole
43"
7th Hole 42"
6th Hole 41"
1-1: The Height Adjustable Legs will come pre-installed into your leg, as shown in Fig. 1-1.
1-2: Start with (1) Height Adjustable Leg, the height from the ground to an elbow is good place to
set the height of fabric surface in above table. Adjustment can be made to comfort from there.
1-3: Remove the M8 X 55mm SBHCS and slide your Height Adjustable Leg to the desired position,
lining up the appropriate holes.
1-4: Insert one (1) M8 x 55mm SBHCS through the hole in the casing and then through the hole in
the Height Adjustable Leg and out the other side, as shown in Fig. 1-2.
1-5: Place (1) M8 Washer and thread one (1) M8 Nylock Nut onto the end of the screw and use the
provided Allen Wrench and Open Ended Wrench to tighten the nut down.
1-6: Repeat Step 1-3 through 1-6 for the remaining (5) Height Adjustable Legs. Remember to
keep the Height Adjustable Legs at the same height.
Note: As a general recommendation, most users from 5'4" to 5'6" tall prefer the legs positioned with
the screws in the sixth hole from the bottom. Preferred heights may vary.
Step 2: Track Support Assembly
Parts Needed:
4- Track Support
16- M6 X 10mm SBHCS
2- Side Leg
1- Middle Leg*
*Note: If you're setting the frame up in Crib Size you will
need to use both Side Legs, not the Middle Leg, (see Fig. 2-1B).
Note: The front of the Side Legs, are the side with the longer
legs, as shown in Fig. 2-1A.
2-1: Attach a track support to the outside holes on the front of the Side Leg with (4) M6 X 10mm
SBHCS.
5th Hole 40"
4th Hole
39"
3rd Hole
38"
2nd Hole 37"
Bottom Hole 36"
Fig. 1-1
Side Leg
SBHCS M8 X 55mm
Track Support
Middle Leg
Casing
M8 x 55mm
SBHCS
Height
Adjustable
Legs
Fig. 2-1A
Short Leg
Long Leg
Side Leg
M6 x 10mm
SBHCS
M8 Washer
M8 Nylock Nut
Fig. 1-2
Height
Adjustable
Leg
Leveling
Foot
Pg.5