Aliph Jawbone User Manual page 8

8. Go back to your mobile phone's main menu. For
certain mobile phone models, once the headset is
activated, a headset icon will be displayed on the
screen. You should now be able to make and receive
calls using Jawbone.
NOTE: After the initial pairing, the phone and Jawbone
will remember each other. Therefore you will not have to
pair your headset with your phone every time you use it.
Just select "Jawbone" from the list of paired devices and
connect to it.
IMPORTANT: If the pairing cannot be completed within
two minutes after the pairing mode has been activated,
Jawbone's LED indicator will flash red and beep three
times. Jawbone will then turn off automatically. Please
repeat steps 2 to 8 above to pair Jawbone and the
mobile phone again.
Using Jawbone after it is Paired and
Connected
1. To answer a call, press the 'TALK BUTTON'
once.
2. To end a call, press the 'TALK BUTTON'
3. If Jawbone is connected to the phone and you make
a call, the audio will automatically be routed to
Jawbone. To make a call using voice dialing, press the
10
'TALK BUTTON'
standby.
4. Jawbone automatically enhances the volume of your
call depending on the noise of your environment. If you
want to adjust the volume of your call further, use your
mobile phone's volume button or press the 'NOISE
SHIELD BUTTON'
volume by one level (there are a total of six levels).
4. Turning Jawbone On and Off
Press and hold the 'TALK BUTTON'
seconds until you hear a short beep. The LED status
indicator will then flash white.
IMPORTANT: After you turn Jawbone on, you may need
to press the 'TALK BUTTON'
pairing and resume the connection between the head-
set and the mobile phone. (For pairing instructions,
please refer to the "Pairing Jawbone" section.)
Turning off Jawbone
To turn Jawbone off, press and hold the 'TALK
once.
BUTTON'
beep. The LED status indicator will flash red and then
go off.
once when Jawbone is in
one time to increase the
one time to reactivate
for three seconds until you hear a long
for three
11