Aliph Jawbone User Manual page 7

3. Pairing Jawbone
Jawbone works with Bluetooth-enabled devices
only. Prior to pairing your headset for the first time,
please ensure that your mobile phone is Bluetooth
capable and the Bluetooth feature is enabled.
The first time that you use Jawbone with your Blue-
tooth-enabled phone, you will have to "pair" them to-
gether. This is a procedure that exchanges informa-
tion between your phone and the Jawbone so that
they can work together. Pairing is only required the
first time you use the Jawbone with your phone. The
headset pairing procedure will vary depending on
the model of your mobile phone. Please refer to your
mobile phone user guide for pairing instructions.
NOTE: Instructions on how to pair Bluetooth devices with
many popular phones can be found on our website at
http://www.jawbone.com.
8
Steps for Pairing Jawbone:
1. Place Jawbone where it is no more than one meter
away from your mobile phone.
2. Ensure Jawbone is off (the LED status indicator
should not be flashing).
3. Activate your mobile phone's Bluetooth function.
Please refer to your mobile phone user guide or
http://www.jawbone.com for details.
4. Press and hold the 'NOISE SHIELD BUTTON'
for 3 seconds until the LED status indicator alternately
flashes white and red. This means Jawbone is now in
pairing mode. This mode will last for 2 minutes or until
pairing is complete.
5. Set the mobile phone to search for all available
Bluetooth devices. When the search is complete, select
"Jawbone" from the list of devices shown.
6. Enter the passkey "0000" and press "OK" to pair
Jawbone with your mobile phone. When the pairing
is completed, Jawbone will beep and the LED status
indicator will then flash white rapidly eight times.
7. If prompted by the phone to connect, select "Yes"
(this will vary between phones).
9