Alienware Area-51 m5750 User Manual page 62

Alienware Area-51 m5750 Technical Reference
Installing a Mini-Card into Your System
To install a new Mini-card, do the following:
1. Follow steps in the previous section, Installing a memory module (DIMM) into
the system, to access the Mini-Card Socket.
2. The mini-card will only fit in one direction. Align the small notch in the module
with the socket on the connector and insert the card at an angle of
approximately 30 degrees into the empty socket. Then press it firmly so that
the contact edge is driven into the receiving socket. Pivot the mini-card and
fasten 2 Screw-E's to hold the card down.
Note: If you want to remove a mini-card from the socket, remove 2 Screw-E's. The card
should pop up to an angle of 30 degree.