Connecting To The Network - Alienware Area-51 m5750 User Manual

Alienware Area-51 m5750 Technical Reference
Ethernet
Your computer is equipped with a 10/100/1000Base-TX Fast Ethernet network adapter.
Connect the active LAN cable to the RJ-45 LAN port located on the left side of the
computer. This allows you to access and transmit data in the local area network.

Connecting to the Network

Use an Unshielded Twisted Pair (UTP) Ethernet cable only.
1. Insert one end of the UTP cable into the network connector until the connector
snaps securely into the receptacle.
2. Connect the other end of the cable to either an RJ-45 jack wall outlet or to an
RJ-45 port on a UTP concentrator or hub in the network.
Cabling Restriction for Networks
The following restrictions should be observed for 10/100/1000BASE-TX networks:
• The maximum cable run length is 100 meters(m) (328 feet[ft]).
• For 100Mbps or 1000Mbps operations, use Category 5 wiring and connections.
Note: Consult the Windows manual and / or Novell Netware user's guide for the software
installation, configuration, and operation of the network.
4