2: Your First Session With The Quadrasynth Plus; Powering Up; Adjusting The Display Contrast - Alesis QuadraSynth Plus Reference Manual

C 2
HAPTER
Y
OUR
T Q
HE

Powering Up

After making your connections, turn on the system's power using this procedure:
¿
items:
• Have all connections been made correctly?
• Are the volume controls of the amplifier or mixer turned down?
• Is the volume of the QuadraSynth Plus turned down?
¡
panel.
Upon power-up, the QuadraSynth Plus will display the last selected Program or Mix. If
this Program/Mix has been edited, the display will indicate this by showing the word
"EDITED" below either the word "MIX" or "PROGRAM."
¬
The best signal-to-noise ratio is achieved when [VOLUME] is set to maximum. This is a
digital volume control, and lower settings have lower resolution.

Adjusting the Display Contrast

QuadraSynth Plus Piano Reference Manual
Your First Session With The QuadraSynth Plus: Chapter 2
F S
IRST
UADRA
Before turning on the QuadraSynth Plus's power, check the following
Turn on the [ON/OFF] (power) switch on the QuadraSynth Plus rear
Turn the QuadraSynth Plus's master [VOLUME] control to maximum.
Turn on the power of the amplifier/mixer, and adjust the volume.
Occasionally, the characters in the LCD display may be difficult to read,
depending on the viewing angle and existing lighting conditions. In such
a situation, adjust the contrast of the LCD display using the following
procedure.
¿ Press [GLOBAL].
The display will change to the Global Page.
Use Quad Knob [1] to adjust the contrast, or use the VALUE [ ]
¡
and [ ] buttons.
The contrast and its value in the display will change.
ESSION
S
YNTH
W
ITH
P
LUS
15