Trouble Shooting; Troubleshooting - Breadman AUTOMATIC BREAD BAKER Instruction Manual

TROUBLE SHOOTING

Symptom
Display Window
shows nothing
START button
doesn't start
the machine
Can't set the Timer
After starting, the
Display Window
flashes "H:E3"
The Bread Machine
doesn't mix the
ingredients
The Breadman ® stops
Possible Solutions
Make sure the machine is plugged in. If nothing appears in
the Display Window, unplug and plug in again.
Make sure the machine is plugged in.
If nothing appears in the Display Window, press
SELECT to choose your Baking Cycle. (You must select
a Baking Cycle before pressing START.)
If the baking area is too hot, the Breadman
because of an automatic safety feature. Remove the Bread
Pan with your ingredients, and wait until the Breadman
cools down — about 20 minutes — before starting a
new loaf.
If you selected either the Rapid Bake or Dough Cycle,
you should not use the Timer. This is because the
ingredients should be processed immediately for
these cycles.
If the Bread Machine is too hot, it will not start because
of an automatic safety feature.
Remove the Pan and let the Bread Machine cool down
until "H:E3" disappears and the selection reappears.
You may then start the cycle.
On preheating the (:) in the Time Display flashes and the
Kneading Paddle will not move. There is a 4 - 5 min. rest
period on some of the cycles in which there will be no
movement in the Pan for 4 - 5 min. If the Kneading
Paddle does not operate after this period of time,
check to see if the Kneading Paddle is engaged in the
machine correctly.
This happens if you press the STOP Button, if you
unplug the machine, or if there is a power outage. In each
case, the Breadman ®
Discard the contents of the Bread Pan and start again
with new ingredients.
16
can't be restarted for this Cycle.
will not start
®
®