Set: System Set - AGFA Anapurna H3200i LED Advanced Operator Manual

4.5.3

Set: System Set

No. Control
1 Factory Set / UV Parameter / UV Power Setting
34 Advanced operation.
Brake Off Time: Blocks the unwinding so that the media can be drawn tight (flat)
manually.
2 Safety
Safety Sensor Enable: this check box overrides the safety sensors (light curtains).
Buzzer Beep Enable: this check box enables/disables the buzzer beep.
3 Use Nozzle
Full Nozzle: All nozzles of the printer heads are used.
Reduction Nozzle -40: First and last 20 nozzles of the printer heads are not used.
Reduction Nozzle -16: First and last 8 nozzles of the printer heads are not used.
Reduction Nozzle -8: First and last 4 nozzles of the printer heads are not used.
4 Version
The data in this field are for informational purposes only.
5 Job Log View
Image preview rotate: Depending on the Image Rip (for us Asanti), it may be that the
job preview is shown rotated on the iGUI screen (upside down and hard to read). By
checking the check-box "Image preview rotate" the preview of the image is rotated
so that it is clearly readable on the Gui screen.
RTL Error Check: check box to perform a RTL error check during loading of an image
(is default off).
Caution:
Despite the fact that the option is available in the software, Agfa strongly advises against disabling a
safety device of the printer. There is a serious risk of bodily harm from the printer's moving parts. All of the
safety sensors should be active during the operation of the machine. Agfa cannot be held responsible for
injuries occurring while any item of the printer's safety devices is not functioning.
www.agfagraphics.com
This button opens the "System Setup" pop-up.
Refer to
Chapter 9
See caution below