Setting The Date And Time - Alesis Fusion Reference Manual

3
Chapter 3: Fusion Modes

Setting the Date and Time

Menu: Global/System/Date/Time
Parameter: Date
Value Range: (Varies; in Month – Day – Year format)
This parameter sets the date for the Fusion's internal clock.
Menu: Global/System/Date/Time
Parameter: Time
Value Range: (Varies: Hour : Minutes : Seconds)
This parameter sets the time for the Fusion's internal clock. Note that
time is set in a 24-hour format instead of an AM/PM system.
Menu: Global/System/Date/Time
Parameter: Calibration
Value Range: -165.85 Sec/Month to 331.39 Sec/Month, N/A
If you find your Fusion's internal clock to be drifting slightly over long
periods of time (for example, over a month), use this parameter to
compensate for clocks that are slightly too fast (or slow). If your clock is
right on, leave this parameter set to "N/A."
Menu: Global/System/Date/Time
Parameter: Clock Enable
Value Range: On, Off
When the Fusion is powered off, its internal clock must always remain
active in order to maintain basic timekeeping functions. Because of this,
the Fusion's internal battery (that powers the internal clock) is very slowly
drained over long periods of time. The "Clock Enable" parameter has
been included so that you can turn the clock off in case you plan to leave
your Fusion off for a long period of time. For normal use, you should
leave this box checked.
If you've turned off the clock, every time you turn on the Fusion, you'll
see a prompt informing you the clock is not accurate. This prompt will
then take you to the Global/System/Date/Time page where you can set
the correct time and re-enable the clock
212