Certified Directory - Alcatel-Lucent OmniSwitch 6850-48 Getting Started Manual

Omniswitch 6850 series
Hide thumbs Also See for OmniSwitch 6850-48:
Table of Contents

Advertisement

Certified Directory

Certified Directory
Intended for: Reliable, Tested configuration
and image files. The switch will roll back
to this software in the event of a system
software error.
On reload: By default, the switch will use
the software in this directory if there are
any differences between the Working and
Certified directories.
Saving changes: You cannot save config-
uration changes to the Certified directory.
To save your changes, be sure that your
switch is operating from the Working
directory.
The software in the /flash/certified directory should be treated
as the "gold master" for the switch. When you place configu-
ration and image files in this directory, you are "certifying"
them as tested and reliable. If the switch is running from the
/flash/working directory and experiences a software problem,
it will "roll back" to the last known good software in the
/flash/certified directory on the next reboot.
June 2007
How can I tell which directory the switch
is currently using?
When you first boot the switch, the /flash/working directory is
used; this allows you to save your initial configuration changes
to the boot.cfg file. However, subsequent boots may result in
your switch running from the /flash/certified directory. There-
fore, verifying the current running directory is a key step any
time you are configuring or monitoring the switch.
View the switch's current running directory by entering the
show running-directory
command. For example:
-> show running-directory
CONFIGURATION STATUS
Running CMM
CMM Mode
Current CMM Slot
Running configuration
Certify/Restore Status
SYNCHRONIZATION STATUS
Flash Between CMMs
Running Configuration
Stacks Reload on Takeover: ALL STACKs (SW
Activation)
In this example, the switch is using the /flash/working direc-
tory. For more information on the show running-directory
command output, refer to the "CMM Commands" chapter in
the OmniSwitch CLI Reference Guide.
: PRIMARY,
: DUAL CMMs,
: 1,
: WORKING,
: CERTIFY NEEDED
: SYNCHRONIZED,
: NOT AVAILABLE,
Files and Directories
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents