Adjust The Switch Time For Door Opener And Light Relay; Programming The Tcs Front-Door Station - TCS FBI6100-0400 Product Information

Adjust the switch time for door opener and light relay

 Register under Settings
hardware.
 Select System in the navi-
gation bar.
 Select the values.
The switch time is to be adjusted by
selecting numbers from 0...99 sec. The
left selection field adjusts the 10th sec-
onds, the right one the 1th seconds.

Programming the TCS front-door station

Program the serial numbers which are used in the phonebook of the FBI610x with con-
figo™ or TCSK-01 at the required buttons of your front-door station.
The buttons of the front-door station can be programmed also manually:
 Switch on the programming mode of the system.
In the operation mode ACTIVE: Shortly press the RUN/PROG button at the FBI610x
or in the operation mode PASSIVE: Shortly press the RUN/PROG button at your
power supply and control unit. The RUN/PROG LED starts blinking.
 First delete already programmed buttons by pressing the button for a long period (see
product information front-door station).
 Call the FBI610x from the number which is allocated to the serial number in the phone-
book. Select a front-door station.
 After the voice connection is established, shortly press the bell button which is to be
programmed. Although a negative acknowledgement tone sounds at the front-door sta-
tion, the button was successfully programmed.
 This function is only available, if the corresponding phonebook entry under incoming
!
is not set on Reject.
 The incoming call number at the FBI610x must be identic with the phonebook entry.
TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de
www.tcsag.de
14
Subject to technical changes.
PI_FBI610x_uk 3 A
02/2014