Radio Repeater Avs14.390; Mounting Method; Connections; Radio Link - Siemens Albatros 2 RVS13 Series User Manual

Mounting method

Connections

Radio link

Establishing the link
Testing

Dimensions and drilling plan

28/109
Siemens
Building Technologies
3.7.4

Radio repeater AVS14.390

· To establish the radio link, the device must be temporarily connected to power prior
to mounting, enabling the radio link to be opened and tested
· The radio repeater must be fitted inside the building
1 2
Power is supplied via the enclosed power pack. The wires are interchangeable.
Tip: Establish the radio link in the vicinity of the radio module prior to mounting so
that all system components are within easy reach.
Prerequisite for the radio link is that all components receive power, which means that
the radio module must be correctly connected to the basic unit and power must be
correctly supplied to the radio repeater.
1. Press the button on the radio module for at least
8 seconds until the LED on the radio module
starts flashing at high frequency.
2. Press the button on the installed radio repeater
until the LED starts flashing at high frequency.
3. The link is established when the LED on the radio
module extinguishes.
The test is made to check the quality of the radio link.
· The test can be stopped by pressing the ESC button
· While the radio link can be opened on the boiler, the test should be made at the
location where the room unit will be installed
1. Press button on the radio repeater for 3 to at most 8 seconds until the LED starts
flashing at low frequency.
2. When radio communication works, the LED on the radio module flashes briefly
at 10-second intervals.
3. After the test, press the button on the radio repeater again briefly until the LED
extinguishes.
90
User Manual
3 Mounting and installation
32
4
Button
4,2
2 1
56
60
CE1U2357en
LED
2014-07-30