Troubleshooting; Maintenance - Aiwa CT-X438 Operating Instructions Manual

TROUBLESHOOTING
MAINTENANCE
Errorcodes
In the following cases the corresponding error
codeindication appears.Follow thesuggestions
belowto solve
the
problem. If the error
code
indication does not disappear, consult an AIWA
setvice center.
ERRORO1
ERROR02
ERROR03
ERROR04
ERROR05
The disc magazine is not properly
inserted in the compact disc
changer. Reinsert the magazine.
Refer to the instruction manual for
the compact disc changer.
No discs are loaded in the disc
magazine. Insert discs properly.
Refer to the instruction manual for
the compact disc changer.
Focus error. Check that the discs
are loaded properly in the disc
magazine (right side up, etc.)
Problem with the compact disc
changer. Reset the unit by
pressing the reset button. If this
does not solve the problem, consult
an AIWA service center.
The compact disc changer is
Meaningthefrontpanel
Whenthe frontpanelis
soiled, wipe the surface
(ofthe panel with a dry and soft cloth.
[cleaning the tape head
Ihe a cleaning
cassette to
clean the playback
Iheadand capstans approximately once a month.
Ilfthe playback head is dirty, the high tones may
not
be reproduced properly.
Cleaning
the connector
'The connector on the reverse side of the front
Ipanel needs to be cleaned occasionally. Wipe
the surface of the connector with a cotton swab
slightly moistened with alcohol.
overheated. Allow thechangerto
cool off by moving the vehicle out
of direct sunlight.
Reset button
The Reset button is visible when you detach the
front panel, Trypressingthis button if a connected
compact disc changer does not operate properly.
To press this button, usethe tip of a pointed
object such as a pencil or toothpick.
Note that all your setting stored in memory,
however, will be erased by pressing this button.
/-,
\
F
II
[01—lq
D
o
B,
Resetbutton
ENGLISH
14